Abit Front Panel Switches & Indicators Headers, NF7/NF7-S/NF7-MNF7-S2/NF7-S2G Hled Pin 1

Page 19

Hardware Setup	2-9

(5). Front Panel Switches & Indicators Headers

This header is used for connecting switches and LED indicators on the chassis front panel.

Watch the power LED pin position and orientation. The mark “+” align to the pin in the figure below stands for positive polarity for the LED connection. Please pay attention to connect these headers. A wrong orientation will only cause the LED not lighting, but a wrong connection of the switches could cause system malfunction.

NF7/NF7-S/NF7-M:NF7-S2/NF7-S2G:

•HLED (Pin 1, 3):

Connects to the HDD LED cable of chassis front panel.

•RST (Pin 5, 7):

Connects to the Reset Switch cable of chassis front panel.

•SPK (Pin 15, 17, 19, 21):

Connects to the System Speaker cable of chassis.

•SLED (Pin 2, 4):

Connects to the Suspend LED cable (if there is one) of chassis front panel.

•PWR-ON (Pin 6, 8):

Connects to the Power Switch cable of chassis front panel.

•PLED (Pin 16, 18, 20):

Connects to the Power LED cable of chassis front panel.

User’s Manual

Image 19

Contents

NF7 Series Copyright and Warranty Notice Table of Contents Appendix a Introduction Features & SpecificationsIeee 1394 NF7-S NF7-S2G Model Chipset Features NF7-SNF7-M NF7-S2Layout Diagram NF7/NF7-S Layout Diagram NF7-M Layout Diagram NF7-S2/NF7-S2G, Ver Install The Motherboard Hardware SetupInstall CPU and Heatsink Chapter Valid Memory Configurations Bank Memory Module Total Memory Install System MemoryTotal System Memory for Un-buffered & Non-ECC DDR 400 Dimm ATX Power Input Connectors Connectors, Headers and SwitchesNF7/NF7-S/NF7-MNF7-S2/NF7-S2G FAN Connectors Cmos Memory Clearing Header Pin 1-2 shorted default Normal operationNF7/NF7-S/NF7-M NF7-S2/NF7-S2G NF7/NF7-S/NF7-M Wake-up HeaderNF7-S2/NF7-S2G Ver SPK Pin 15, 17, 19 Front Panel Switches & Indicators HeadersNF7/NF7-S/NF7-MNF7-S2/NF7-S2G Hled Pin 1 RST Pin 5Infrared Device Header NF7/NF7-S/NF7-M VCC Additional USB Port HeadersAdditional IEEE1394 Port Headers NF7-S Front Panel Audio Connection Header NF7-S2/NF7-S2G Internal Audio Connectors Accelerated Graphics Port Slot Floppy Disk Drive Connector IDE Connectors NF7-S2/NF7-S2G Serial ATA Connectors NF7-S/NF7-S2/NF7-S2G Status Indicators System Management Bus Headers Back Panel Connectors NF7/NF7-S NF7-M NF7-S2/NF7-S2G AUDIO1 Esc Bios SetupF10 CPU Operating Speed SoftMenu SetupCPU Name Is CPU Internal FrequencyCPU FSB/DRAM ratio Power Supply ControllerMultiplier Factor AGP FrequencyFSB Frequency Brand NameFrequency System PerformanceCAS Latency Time Row-active delayRAS-to-CAS delay Row-precharge delayNF7/NF7-S/NF7-M NF7-S2/NF7-S2G Date mmddyy Standard Cmos FeaturesTime hhmmss Capacity NF7/NF7-S/NF7-M NF7-S2/NF7-S2G IDE HDD Auto-DetectionPrecomp Floppy 3 Mode SupportCylinder HeadExtended Memory Base MemoryAdvanced Bios Features Swap Floppy Drive Boot Up Floppy SeekBoot Up NumLock Status Apic ModeReport No FDD For OS Delay IDE InitialFull Screen Logo Show NF7-S2/NF7-S2G System Bios Cacheable Advanced Chipset FeaturesFSB Spread Spectrum Video RAM CacheableAGP Aperture Size Frame Buffer Size For NF7-M onlyAGP 8X Support AGP Aperture Size MBSpecial I/O for PCI Card OnChip IDE1 Controller Master/Slave Drive PIO ModeIntegrated Peripherals OnChip IDE DeviceOnChip PCI Device IDE Prefetch ModeOnChip IDE2 Controller IDE Bus MasterIEEE1394 Controller For NF7-S Only LAN Boot ROMAudio Controller LAN ControllerOnboard FDD Controller IR Transmission DelayUse IR Pins EXT-P2P’s Discard TimeIDE Function Setup Parallel1 Port ModeEPP Mode Select ECP Mode Use DMAOnChip IDE-1/IDE-2 Controller Onboard DeviceSerial-ATA USB KB. Storage SupportSuperIO Device Sata Spread SpectrumInit Display First Power Management Setup KB Power On Password Power-On by Alarm NF7-S2/NF7-S2GDay of Month Alarm/ Time hhmmss Alarm Power On FunctionRestore on AC Power Loss IRQ Resources PnP/PCI ConfigurationsForce Update Escd Resources Controlled ByAllocate IRQ to USB PCI Latency TimerPCI/VGA Palette Snoop Allocate IRQ to VideoAssign IRQ for VGA NF7-S2/NF7-S2GPirq 0 Assignment ~ Pirq 3 Assignment Assign IRQ for USBCPU Warning Temperature CPU Shutdown Temperature / Shutdown TemperaturePC Health Status Save & Exit Setup Load Fail-Safe DefaultsLoad Optimized Defaults Set PasswordNF7 Series Appendix A. Install Nvidia nForce Chipset Driver Click Continue Anyway Appendix B. Install Integrated GPU Driver NF7-M Appendix B Appendix C. Install USB 2.0 Driver Appendix C Appendix D. Install LAN Driver NF7-S2G Appendix D Appendix E. Install Serial ATA Driver NF7-S Click Finish Main Menu Bios Setup for Serial ATA RAIDRAID Configuration Utility Menu Array ModeOption Rebuild Mirrored set Option Delete RAID setOption Resolve Conflicts Define a New Array Appendix F. Bios Setup for Nvraid NF7-S2/NF7-S2GSetting Up the Bios Nvidia RAID Utility MenuAssinging the Disks Selecting the RAID ModeArray Detail Array ListNF7 Series Appendix G. Abit EQ The Hardware Doctor Utility Appendix G Appendix H. FlashMenu Bios Update Utility Appendix H Appendix I. Troubleshooting Need Assistance? Example Main instructions Technical Support Form Appendix J. How to Get Technical Support Alt.comp.hardware.homebuilt alt.comp.hardware.pc-homebuilt 4QX, UK Thank You Abit Computer Corporation