IBM Ricoh 2400 dpi manual Installing the device driver, Scanner installation

Installing the device driver

Run the Info Technician to install the scanner drivers. To do so:

1 . Insert disk 1 of the Info Technician into the computer’s floppy drive.

2.In Windows Program Manager, select the Run command from he File menu. If you are using Windows 95, select Run from the Start menu on the desktop.

3.Type A:\SETUP at the command line and click OK. Substitute the appropriate drive letter if the disk is not in the A drive.

4.Follow the on screen directions.

The scanner’s device driver is installed in the proper directory, along with the TWAIN driver.

5.Reboot the computer after the installation is complete to activate the scanner drivers.

Mac and compatibles installation

The ImageReader FB is capable of running on a Macintosh or Mac compatibles as well as PCs. If this unit shipped with Mac software and a plug-in driver (not all models do), read this section for instructions about installing this scanner on your Mac system.

Scanner installation

Set the scanner to a unique SCSI ID. Attach the 50-pin SCSI terminator block to the port on the scanner, and connect the SCSI cable to the terminator block. Pace the scanner unit In the desired location, and route the interface cable to the computer in such a way as to assure it is safe from possible damage due to pinching or crimping. Insert the 25-pin male connector on the cable into the SCSI port on your Mac, or the last device on your chain. The cable can only be inserted one way - do not force a connection. Connect the power cable as well.

Once the scanner is attached and near the location you want it, unlock the scanning mecha- nism. The scanner is locked for transport to avoid damage to the assembly. You must unlock the scanner