Hyundai W220D manual Selecting a suitable location Connecting the PC

Page 9

3-2. Selecting a suitable location

3-3. Connecting the PC

15 pin D-sub / DVI-D /

HDMI

W220D

Multi Function Wide Monitor

Place the monitor at least 30cm from other electrical or heat-emitting equipment and allow at least 10cm on each side for ventilation.

Place the monitor in a position where no light shines directly onto or is reflected on the screen.

To reduce eye strain, avoid installing the display unit against a bright background such as a window.

Position the monitor so that the top of the screen is no higher than eye level.

Position the monitor directly in front of you at a comfortable reading distance (around 45 to 90cm)

! Before you start cabling your monitor, check that the power is off on all units. To avoid any possibility of electric shock, always connect your equipment to properly earthed outlets.

1.Insert the other 15-pin/DVI-D/HDMI signal cable connector into the 15-pin VGA/DVI-D connection on your computer and screw it down.

2.Plug the power cord connection to connection on the monitor.

3.Plug the other end of the power cord to your computer's main supply or to a 100V-240V earthed electrical outlet.

4.Turn on the monitor using the power switch and check that the power LED is on. If not, repeat steps 1,2,3 and 4 or refer to the Troubleshooting section of this guide.

5/22

Image 9
Contents User’s Guide Page Declaration of Conformity W220D Multi Function Wide Monitor Introduction Safety Information W220D Multi Function Wide Monitor Cleaning and Maintenance Installing the monitor Selecting a suitable location Connecting the PC Way to Connect Speaker Setting the refresh rate Preset Timing Table 10/22 11/22 Adjusting the picture 13/22 14/22 15/22 16/22 17/22 Display power management Troubleshooting 20/22 21/22 Specifications
Related manuals
Manual 26 pages 53.37 Kb