Hitachi Koki USA HV-F202SCL Specification of Digital output connector, PIN no, Trig-A / Vd H

1 2 3 4

A

B

C

D

E

F

6.Specification of Digital output connector

(1)DCIN connector

PIN NO.	Signal		PIN NO.	Signal
1	GND (+12V)		7	TRIG-A / VD (H) IN
2	+12V		8	TRIG-B (C) IN
3	GND		9	TRIG-B (H) IN
4	N.C.		10	FLASH / VD OUT
5	N.C.		11	N.C.
6	N.C.		12	TRIG-A / VD (C) IN
Connector (camera side)		: SAMWOO SNH-10-12 (RPCB) or equivalent

Plug (matching cable plug) : Hirose HR10A-10P-12S (01) or equivalent

Please do not unplug and insert cable (camera cable) with a power supplied to a camera. Install clamp filter (ZCAT 2035-0930A: TDK) at both ends (camera and video processor ends) in the CE marking region.

TRIG-A/VD and TRIG-B are photo coupler input, 8/12/5 pin isisolated with 1/3 pin. When 8/12/5 pin is connected to GND, please connect to 3 pin.

Note: Please do not input any signal to N.C. pin because machine may break down.

(2) DIGITAL OUT connector

(a) Interrelation between number of DATA bits and number of used connector

		Number of Data bits		D.OUT1			D.OUT2
1	24bit (R: 8bit G: 8bit B: 8bit)				O		-	O: Use
2	30bit (R: 10bit G: 10bit B: 10bit)				O		O	-: Not use
3	36bit (R: 12bit G: 12bit B: 12bit)				O		O
			26			13

14 1

D.OUT1D.OUT2

		DWG.No.	E400234503			7
						SHEET
							17
1	2		3		4
				DF022-4PE-S1

A

B

C

D

E

F