Hitachi Koki USA CMP4120HDUS Reset Settings Initialization, Signal Check, Status Display Action

Reset (Settings Initialization)

■ The EasyMenu shown to the right will be displayed when the SELECT button is

used to select DISPLAY and moreover
DISPLAY INIT is selected from the On-screen	INITIALIZE ?
Display System Easy Menu 12 . If the key
	YES	NO
(select YES) of the SELECT button is pressed
at this time, the user adjustment values in the
table below for the signal currently being
received will be deleted and the factory settings
will be restored.

• Pressing the key (select NO) cancels deletion and returns the DISPLAY MENU.

DISPLAY menu item	Display	Application
Horizontal position	H.POSITION	RGB1, RGB2
Vertical position	V.POSITION	RGB1, RGB2, VIDEO1, VIDEO2
Dot clock frequency	CLOCK	RGB1, RGB2
Dot clock phase	PHASE	RGB1, RGB2
Vertical size	V. SIZE	VIDEO1, VIDEO2

ENGLISH

Signal Check

■Changes in the signal status are displayed on the screen as they arise.

Status	Display	Action
The input signal was	• The input terminal and the
switched or the
	horizontal and vertical	-
RECALL button was
	frequencies are displayed in
pressed after AUTO
	a guidance image.
FREQ was turned on.
	• The guidance message
	“POWER SAVE” is
	displayed for about 5

A sync signal could not	seconds.	• Check the power switch of
	• In the event of continued	the PC and its status of
be detected.	absence of a sync signal,	connection.
			27	29
	the power indicating lamp
	flickers and the monitor
	enters power save mode.
The input signal does	• The guidance message	• Check the input signal
not meet display	“OUT OF FREQUENCY” is
		specifications once again.
specifications or erratic.	displayed.

RGB

RGB1 [D-SUB]

H : 46.5kHz, V : 60.0Hz

VIDEO

VIDEO1

Either VIDEO or S VIDEO is displayed on VIDEO input.

POWER SAVE

OUT OF FREQUENCY

21