Hanns.G HA191 manual Installation Instructions, User’s Manual, Remove, Removal, Power Source

Page 9

INSTALLATION INSTRUCTIONS

User’s Manual

INSTALLATION INSTRUCTIONS

INSTALL

REMOVE

Figure.1. Installing and Removing the Base

INSTALLATION:

1.Align the monitor with the opening in the base.

2.Note that the longer section of the base points forward.

3.Snap the monitor into its base. A clear click sound will affirm that the base is connected correctly.

4.Verify that the monitor is securely attached to the base by looking at the bottom of the base and making sure that the clips are fully engaged in the base.

REMOVAL:

1.Flip over the monitor so that it is upside down.

2.Press the 2 clips on the base that holds the monitor in place.

3.Gently press and hold the 2 clips while pulling the base from the monitor unit they are unattached.

POWER

POWER SOURCE:

1.Make sure that the power cord is the correct type required in your area.

2.This LCD monitor has an Internal universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required.)

3.Connect the AC-power cord one end to your LCD monitor’s AC-input socket, the other end to wall-outlet.

9

Image 9

Contents HSG1097 HA191FCC Class B Radio Frequency Interference Statement User’s ManualCANADA Ergonomics CongratulationsEnergy EmissionsRECYCLING INFORMATION ERROR MESSAGE & POSSIBLE SOLUTIONS TABLE OF CONTENTSPRECAUTIONS SAFETY NOTICELamp Disposal SPECIAL NOTES ON LCD MONITORSCHECKING THE CONTENTS OF THE PACKAGE FEATURESBEFORE YOU OPERATE THE MONITOR The product package should include the following items LCD MonitorPOWER INSTALLATION INSTRUCTIONSINSTALL INSTALLATIONSETTING THE MONITOR ON THE WALL DISSEMBLING THE STAND BASEWALL MOUNTING THE MONITOR CONNECTING TO A PC MAKING CONNECTIONSADJUSTING THE VIEWING ANGLE GENERAL INSTRUCTIONS OPERATING INSTRUCTIONSPower Button FRONT PANEL CONTROLPower Indicator AdjustThe screen resolutions available will depend on the purchased model ResolutionINPUT SETTING HOW TO ADJUST A SETTINGSCOLOR SETTING IMAGE SETTINGOSD SETTING INTERMEDIATE, and MAXIMUM. This feature is limited toavailability of this function depends upon the selected model onlySYSTEM PLUG AND PLAY Plug & Play DDC2B Feature TECHNICAL SUPPORT FAQ Q & A FOR GENERAL PROBLEMSdesktop and select PropertiesSettingsScreen User’s Manual FACTORY PRESET TIMING TABLE ERROR MESSAGE & POSSIBLE SOLUTIONSRESOLUTION ƒ CABLE NOT CONNECTED1280×1024 @72Hz SXGA 1280×1024 @60Hz 1280×1024 @75Hz 76.02 79.976 79.97671.448 75.025 75.025 APPENDIX SPECIFICATIONS