Specifications, PD11SP Features | ETA Systems PD11VP, PD11SS

ETA’s line of Conditioned Power Distribution units are designed to reduce damage to sensitive electronic equipment

from sudden voltage spikes, damaging power surges, and EMI/RFI noise, which is inherent in utility power lines. The PD11SP is a sequential four step/stage power up/down conditioned power distribution unit. It is designed to

protect electronic equipment that requires a time-delayed start-up, particularly when high in-rush current can poten- tially damage audio, video, or computer equipment at power up.

PD11SP units are shipped with the ability to be linked or daisy chained. All linked units function as slaves; however, slaves can be set to specific time delays. Any number of units can be linked together with a distance of up to 1000 feet between each location (see Fig. 4).

1 thru 4 steps/stages in sequential power up/	Breaker protected and unswitched
down 1, 5, 10, 30 second pre-sets	15 amp outlet

					20 amp total unit breaker
				15 amp front panel outlet breaker
Sequential		Protection "On"		15 amp front panel outlet breaker
Sequential		Protection "On"	Power switch
	On / Off	Indicators	On / Off
						Input RCA phono jack
						Output RCA phono jack
						3 pin terminal block for remote
						3 pin terminal block for remote
						sequential operation of unit
				Output screw terminal
Stage 1	Stage 2	Stage 3	Stage 4	Input screw terminal

PD11SP Features:

•Microprocessor monitored sequential power distribution system

•Four power up/down steps or stages of distributed and conditioned power

•Four pre-set power up/down intervals of 1, 5, 10 or 30 seconds

•Optional manual settings for up to 240 seconds between intervals

•One dual 20 amp U-grounded outlet per stage

•Full 20 amps, 2400 watts capacity per unit

•12-gauge, 3-prong, 10-foot, 20-amp power cord. Requires 20 amp circuit and receptacle outlet

•Protected "always on" 15 amp AC power outlet on the front panel

•Total unit 20 amp and 15 amp outlet circuit breakers located on front panel

•Three-stage spike and surge protection

•Two-stage EMI/RFI filtration

•Ground and AC line fault check

•One rack space high

•One year limited warranty

Other Features:

•Remote control operation

•Standard rear panel RCA connectors and 2 screw terminals

Specifications:

Dimensions	19" L x 10" D x 1 3/4" H
Weight	10 lbs.
Quality	Black powder coated chassis, black anodized aluminum front panel
Electrical	120V, 50/60 Hz, single phase
Max. amps	20/unit
Max. watts	2400/unit
Max. front outlet	15 amps
Spike/surge protection	Line to neutral, neutral to ground, line to ground
Clamping level	200V peak
Response time	1 nanosecond
Max. surge voltage	6000V
Max. surge current	26,000 amps
Max. spike energy	630 joules total
Noise attenuation	Transverse greater than 20 dB, 1.5 kHz to 200 MHz
Certification	ETL listed