EVGA 131-K8-NF44-XX manual DIMM1 & DIMM3 Dual Channel DIMM2 & DIMM4 Dual Channel

DIMM4 (BANK0+BANK1)

DIMM3 (BANK2+BANK3)

DIMM2 (BANK4+BANK5) DIMM1 (BANK6+BANK7)

DIMM1 & DIMM3: Dual Channel 1

DIMM2 & DIMM4: Dual Channel 2

NOTE!When you install the DIMM modules fully into the DIMM socket the eject tab should be locked into the DIMM module very firmly and fit into its indention on both sides.

WARNING! When the DDR SDRAM CLOCK is set at 200MHz, use only DDR400 compliant DDR Modules. When this motherboard operates at 200Mhz, most systems will not even boot if non-compliant modules are used because of the strict timing issues involved, if your DDR Modules are not DDR400-compliant, set the SDRAM clock to 133MHz to ensure system stability.

EVGA Corporation 2900 Saturn St. Suite B, Brea, CA 92821

Phone: 888 / 881-EVGA - 714 / 528-4500 - Fax: 714 / 528-4501

Page 14