3 Removing the drive’s service access cover
3.Remove the drive carrier by grasping the handle and pulling it straight out of the library. The drive carrier weighs about 5 pounds; make sure you support the bottom of the carrier as you remove it.
3Removing the drive’s service access cover
Follow these steps if you are installing a tape drive in an empty slot.
1.From the back panel, use a #2 Phillips screwdriver to release the two captive screws that secure the service access cover to the library.
Captive screws
2.When the screws are loosened, remove the drive access cover.
March 2002 | Page 5 of 12 |