Exabyte EXB-8205 manual 302967

5.Slide the tape drive into the drive bay and secure the drive to the bay as instructed in you computer system documentation.

6.If you needed additional chassis grounding, connect a 1⁄4-inch female spade connector to the ground tab at the rear of the tape drive. Or, connect an M3-0.5 6 mm self-tapping screw to the grounding hole. The ground tab and grounding hole are shown in Figure 7.

Note: The power supply returns are connected to the chassis, so you cannot isolate logic common ground from chassis ground.

Figure 7 Location of ground tab, grounding hole, and power connector on the back of the CTS

16 EXB-8205 and EXB-8505 (Standard and XL) 302967