Envision Peripherals EN9410 user manual General Notes

Page 5

GENERAL NOTES

The following symptoms are normal with LCD monitor and do not indicate a problem.

Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears.

You may find slightly uneven brightness on the screen depending on the desktop pattern you use.

The LCD panel used in this monitor is a very high technology product with 3,932,160 thin film transistors giving you fine picture details. Occasionally, a few non-active pixels may appear on the screen as a fixed point of red, green, blue, white or black. Please note that this does not indicate a defective panel.

Due to the nature of the LCD screen, an after-image of the previous screen may remain after switching the image when the same image has been displayed for a long time. The monitor will slowly recover from this.

LCD monitors have a fixed size & number of pixels. Due to this, an interpolation is necessary to operate the monitor in a resolution below its native resolution which may slightly de-grade the display quality. Therefore, it is highly recommended to operate this monitor at its native resolution of 1280x1024 @ 60Hz.

iv

Image 5
Contents By Envision Peripherals Inc EN9410FCC Class B Radio Frequency Interference Statement For Your SafetyPrecautions Iii General Notes Other Notes Dealer Information DisclaimerMonitor Information Table of Contents Important Safety Instructions Power Saving Auto Adjustment FunctionHigh Quality Expansion On Screen DisplayUnpacking the Monitor Installation and Removal of the BaseHardware Installation Windows XP Windows driver InstallationWindows 98, ME, Click OK to close Display Properties Setting the Display ResolutionPlease Note Supported Graphics Modes and Refresh Rate SelectionIncoming display mode Input timing Picture Optimisation Adjusting the MonitorOSD Menu Clock User defined Color Adjustment OtherImage is blurred, how can I get the best quality picture? Frequently Asked QuestionsNo image is displayed, what can I do? Display shows no Signal error messageImage is or distorted, flashes or flickers Image is displaced in one directionDisplay shows OUT of Frequency error message Image Position, Phase, Pixel Controls Mains power switch, AutomaticModel On-Screen Display FunctionsSignal Connection Video SignalSafety CSA, cULus, TUV/GS Line Frequency