Installation Instructions, Powercord | Envision Peripherals EN7220

EN7220

INSTALLATION INSTRUCTIONS

INSTALLING & REMOVING THE BASE

Install

Remove

Figure 1 - Installing and Removing the Base

POWERCORD

Power Source:

1.Make sure that the power cord is the correct type required in your area.

2.This LCD monitor has an internal Universal Power Supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required.)

3.Connect the AC-power cord into your LCD monitor’s AC-power-input. The AC-power cord may be connected to either a wall power outlet or the power outlet socket on your PC, depending on the type of power cord supplied with your LCD monitor.

A certified power supply cord has to be used with this equipment. The relevant national installation and/or equipment regulations shall be considered. A certified power supply cord not lighter than ordinary polyvinyl chloride flexible cord according to IEC 60227 (designation H05VV-F 3G 0.75mm2 or H05VVH2-F2 3G 0.75mm2) shall be used. As an alternate, a flexible cord of synthetic rubber according to IEC 60245 (designation H05RR- F 3G 0.75mm2) shall be used.

The accessory power cord for the Northern American region is the wall plug with NEMA 5-15 style and is UL listed and CSA labeled. The voltage rating for the power cord shall be 125 volts AC.