Envision Peripherals user manual PrecautionsEN7400e

Page 3

PrecautionsEN7400e

Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.

Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance. Use only a cart or stand recommended by the manufacturer or sold with the monitor. If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow the kit instructions.

Slots and openings in the back and bottom of the cabinet are provided for ventilation. To ensure reliable operation of the monitor and to protect it from overheating, be sure these openings are not blocked or covered. Do not place the monitor on a bed, sofa, rug, or similar surface. Do not place the monitor near or over a radiator or heat register. Do not place the monitor in a bookcase or cabinet unless proper ventilation is provided.

The monitor should be operated only with the type of power source indicated on the label. If you are not sure of the type of power supplied to your home, consult your dealer or local power company.

Do not overload power strips and extension cords. Overloading can result in fire or electric shock.

The monitor is equipped with a three-pronged grounded plug, a plug with a third (grounding)

pin. As a safety feature, this plug will only fit into a grounded power outlet. If your outlet does not accommodate the three-wire plug, have an electrician install the correct outlet, or use an adapter to ground the appliance safely. Do not defeat the safety purpose of the grounded plug.

Unplug the unit during a lightning storm or when it will not be used for long periods of time. This will protect the monitor from damage due to power surges.

Never push any object into the slot on the monitor cabinet. It could short circuit parts causing a fire or electric shock. Never spill liquids on the monitor.

Do not attempt to service the monitor yourself; opening or removing covers can expose you to dangerous voltage and other hazards. Please refer all servicing to qualified service personnel.

To ensure satisfactory operation, use the monitor only with UL-listed computers which have appropriately configured receptacles marked between 100 - 240 V AC, Min. 5A.

The wall socket should be installed near the equipment and should be easily accessible.

Disconnect the power cord to stop the power supply to the monitor.

EN7400e

3

12OCT04

 

Image 3
Contents Inch TFT LCD Monitor User’s ManualFCC Statement For Your SafetyPrecautionsEN7400e Using the Right Power Cord Special Notes on LCD MonitorsGeneral Notes Installing & Removing the Base General Features Package ContentsBefore You Operate the Monitor Connecting the Wires Using the Power Cord Supplied Before You Operate the Monitor Install An Optional Wall Mounting Arm Not supplied How to Install INF & ICM File Adjusting the Viewing AngleFront Panel Buttons Operating InstructionsAdjusting the OSD Settings Plug & Play DDC1/2B Feature Problem Possible Solution Technical Support FAQError Message Possible Solution Possible Solution Error MessageAppendixEN7400e SpecificationsEPA Energy Standard Resolution Horizontal Vertical Pixels Frequency Factory Preset Timing TablePin Number Description Connector Pin Assignment