Envision Peripherals EN-5100E user manual Adjusting the OSD Settings

Page 10

Operating Instructions

EN-5100e

Adjusting the OSD Settings

1.Press the MENU button to open the OSD window.

2.Press the < or > buttons until the desired function is highlighted.

3.Press MENU to open the function’s window.

4.Press the < or > buttons to change the settings of the function.

5.To save and exit, highlight the EXIT icon and press MENU or leave the monitor alone for 10 seconds. If you want to adjust any other function, repeat steps 2-4.

Note: When the OSD window is open, the input signal timing settings appear at the top.

H:stands for horizontal frequency and

V:stands for vertical frequency.

EN-5100e

10

31MY02

Image 10

Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautions Special Notes on LCD Monitors Using the Right Power CordGeneral Notes Package Contents Installing & Removing the Base General FeaturesBefore You Operate the Monitor EN-5100e Connecting the Wires Using the Power Cord Supplied Before You Operate the Monitor EN-5100e Adjusting the Viewing Angle Before You Operate the MonitorOperating Instructions Front Panel ButtonsAdjusting the OSD Settings Plug & Play DDC1/2B Feature How to Install INF & ICM FileTechnical Support FAQ Problem Possible SolutionError Message Possible Solution Resolution Chart Resolution Vertical Pixels FrequencySpecifications AppendixEN-5100eOptimal Viewing Mode 1024 x 768 x 75 Hz AppendixFactory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number Description