Connecting The Cables

female configuration.

EN7220

INSTALLATION INSTRUCTIONS (Cont)

Supplied with units intended for connection to power outlet of personal computer: Please use a cord set consisting of a minimum No. 18 AWG, type SJT or SVT three conductors flexible cord. One end terminates with a grounding type attachment plug, rated 10A, 250V, CEE-22 male configuration. The other end terminates with a molded-on type connector body, rated 10A, 250V, having standard CEE-22

Please note that power supply cord needs to use VDE 0602, 0625, 0821 approval power cord in European counties.

Figure 2 Connecting Cables

AC Power Cord

15-pin D-SUB Cable

Turn off your computer before performing the procedure below.

1.Connect the female end of the AC power cord to the AC-in port on the back of the monitor. Connect the other end to a nearby AC-outlet.

3.Connect one end of the 15-pin D-Sub cable to the back of the monitor and connect the other end to the computer’s D-Sub port.

4.Turn on your monitor and computer. If you monitor diplays an image, installation is complete. If not, refer to the FAQ (frequently asked questions) section for troubleshooting.