7.Using the 7/16” wrench, unscrew the stock brass elbow out of the turbocharger housing. Using the 7/16” wrench, install the supplied brass elbow,
Fueling Adjustment
The Power Edge EZ CAT Module features 4 different levels of fueling. The Module is set default to level 2.
1.To change settings remove the front panel by using a 3/32” allen wrench to remove the two screws.
2.Below the cover the 3 jumper settings on the right side are used for the power level adjustment.
3.The two jumpers can be repositioned in any of the locations shown below to achieve the desired response.
|
| Jumpers | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Power Level 1 | EZ PC Board | ||
| |||
|
| Jumpers | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Power Level 2 | EZ PC Board | ||||
|
|
| |||
|
| Jumpers | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Power Level 3 | EZ PC Board | ||||
|
|
| |||
Jumpers
Power Level 4
EZ PC Board
Power Gains
The following power gains are representative of an actual test vehicle. Power gains may vary somewhat on a different vehicle or in different geographic settings.
Level 1: | 25 HP |
Level 2: | 30 HP |
Level 3: | 35 HP |
Level 4: | 40 HP |
8