Boost Sensor Connection
1.The boost sensor is located on the driver’s side of the engine as shown in the photo. Disconnect the stock connector and plug in the supplied connectors that are located closest to the Power Edge EZ CAT module.
Boost Sensor
IAP Sensor Connectors
IAP Sensor Connection
2.The IAP sensor is located on the driver’s side towards the front of the engine. Disconnect the stock connector and plug in the connectors located at the end of the EZ CAT harness (furthest from the module).
Final Inspection and Operation
3.The EZ CAT Module can mount on or near the firewall. Adhere the module using the supplied velcro.
4.Recheck all connections, fittings and fasteners for a properly secure installation.
5.Using the supplied wire ties, secure the wiring harness from possible damage.
Boost Elbow Installation (Optional)
The installation of the brass elbow permits the turbo boost pressure to increase without the wastegate opening. The Power Edge EZ CAT Module will operate equally well with or without this installed.
6.Using the pliers, remove the crimp style clamp from the hose on the stock brass elbow located on the bottom side of the turbocharger. Remove the hose from the brass elbow and dispose of the crimp style clamp.
7