Speaker Location and Mounting Tips

THE FIRST STEP IS THOROUGH PLANNING BEFORE THE INSTALLATION BEGINS.

THE SPEAKER SCREW HOLE CONFIGURATION WILL WORK WITH MOST DOMESTIC AND FOREIGN VEHICLES.

FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE PROPER IMAGING AND MAXXIMUM PERFORMANCE.

Factory Speaker Replacement Location and Installation

1.Before you alter the vehicles interior materials, be sure there is adequate room and clearance for the speaker depth to clear the windows and other moving parts. (See speaker measurement page).

2.If you are using the speaker wires provided in this kit, be sure

to route wires through the factory door grommet as shown in the speaker mounting diagram.

3.After securing the speaker and checking clearances, connect the red/black speaker audio wires to the correct speaker + and - spade terminals.

Custom Speaker Location and Installation

1.Follow steps 1-3 above.

2.Use the speaker mounting diagrams and speaker hole cut-out dimensions on the following pages.

3.Always mount the left and right side speakers on the same plane. This means that each speaker should be the same height from

the floor and same distance from the firewall. Do not mount one speaker higher, lower, further forward or further behind the other.

3.It is generally best to keep the tweeter (component speakers) as close to the mid range driver as possible. Typically with-in 12”.

The tweeters sound best when directed up, towards the rear center of the vehicle.