Dell manual Cabling a PowerEdge R415 System Installed in Static Rails

Page 11

Cable Routing Procedures for Dell™ PowerEdge™ R415 Systems

Figure 10: Disconnecting the Inner CMA Attachment Bracket

Figure 11: Replacing the Outer Power Supply

Disconnected inner

CMA bracket

Section 4: Cabling a PowerEdge™ R415 System Installed in Static Rails

NOTE: The CMA is compatible with the sliding rails only, not the static rails.

1.Follow the instructions contained in the Rack Installation Instructions found in the static rail kit to install the server into a two-post or four-post rack.

2.Install the hook and loop straps provided in the rail kit through the slots in the rear brackets of the rails as described in the Rack Installation Instructions.

3.Connect all applicable cables to the rear of the system and verify that all connections are secure.

Page 9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Cable Routing Procedures for Dell PowerEdge R415 Systems Cable Routing Procedures for Dell PowerEdge R415 Systems Contents Introduction Connecting the CMA Cables to the SystemRouting the Cables Through the CMA Installing the Inner CMA Attachment BracketRouting the Power Cables Through the Strain Reliefs Routing the Cables Through the CMA Left-Side Mounting InstructionsAttaching the KVM Dongle to the CMA Basket Right-Side Mounting Instructions Left-Side Mounted CMA Installation PreferredRemoving the CMA Brackets for Shallow Racks Cabling a Dell PowerEdge R415 System Without a CMARouting the Cables CMA Replacing a Power Supply on a PowerEdge R415 System With aDisconnecting the Inner CMA Attachment Bracket Cabling a PowerEdge R415 System Installed in Static RailsCabling a System Installed in Static Rails
Top Page Image Contents