Error Messages | Description |
THE FILE BEING COPIED IS TOO LARGE FOR THE DESTINATION DRIVE
Restart the computer. If the error appears again,contact Dell.
The file that you are trying to copy is too large to fit on the disk, or the disk is full. Try copying the file to a different disk or use a larger capacity disk.
A FILENAME CANNOT CONTAIN ANY OF | Do not use these characters in filenames. |
THE FOLLOWING CHARACTERS: \ / : * ? " < |
|
> - |
|
GATE A20 FAILURE | A memory module may be loose. Reinstall |
| the memory modules and, if necessary, |
| replace them. |
GENERAL FAILURE | The operating system is unable to carry |
| out the command. The message is usually |
| followed by specific information. For |
| example, Printer out of paper. Take the |
| appropriate action. |
The computer cannot identify the drive | |
ERROR | type. Shut down the computer, remove the |
| hard drive, and boot the computer from a |
| optical drive. Then, shut down the |
| computer, reinstall the hard drive, and |
| restart the computer. Run the Hard Disk |
| Drive tests in the Dell Diagnostics. |
The hard drive does not respond to | |
0 | commands from the computer. Shut down |
| the computer, remove the hard drive, and |
| boot the computer from a optical drive. |
| Then, shut down the computer, reinstall |
| the hard drive, and restart the computer. If |
| the problem persists, try another drive. |
| Run the Hard Disk Drive tests in the Dell |
| Diagnostics. |
| The hard drive does not respond to |
| commands from the computer. Shut down |
| the computer, remove the hard drive, and |
54