Table 7. Diagnostic Beep Codes
Beep | Description | Possible Cause/Troubleshooting |
|
| Steps |
|
|
|
1 | BIOS ROM checksum in progress of | System board failure, covers BIOS |
| failure. | corruption or ROM error |
2 | No RAM detected | If no memory is detected, you can |
perform the following steps:
• reseat the memory if an additional memory is available
• install that memory if the issue persists
• issue with the memory connector
3
4
• Chipset Error (North and | System board failure |
| |
South Bridge Chipset, |
|
DMA/IMR/Timer Error) |
|
•
•Gate A20 failure
•Super I/O chip failure
•Keyboard controller test failure
RAM Read/Write failure | If no memory is detected, you can |
| perform the following steps: |
| • reseat the memory if an |
| additional memory is available |
| • install that memory if the |
| issue persists |
| • issue with the memory |
| connector |
5 | CMOS battery failure. Reseat the | |
|
| battery. If issue persists, there can be |
|
| an issue with the |
|
| the connector (that will involve |
|
| replacing the system board) |
6 | Video BIOS Test Failure | Video card failure |
7 | Processor Failure | Processor failure |
8 | Display | Display failure |
54