Dell 9100 service manual

Page 4

Before You Begin: Dell Inspiron XPS and Inspiron 9100 Service Manual

NOTE: Ensure that the computer is off and not in a power management mode. If you cannot shut down the computer using the computer operating system, press and hold the power button for 4 seconds.

4.If the computer is connected to a docking device (docked), undock it.

5.Disconnect the computer from the electrical outlet.

6.To avoid possible damage to the system board, wait 10 to 20 seconds and then disconnect any attached devices.

7.Disconnect all other external cables from the computer.

8.Remove any installed PC Cards from the PC Card slot.

9.Close the display and turn the computer upside down on a flat work surface.

NOTICE: To avoid damaging the system board, you must remove the main battery before you service the computer.

10.Slide and hold the battery-bay latch release on the bottom of the computer, and then remove the battery from the bay.

11.Remove any installed memory modules, Mini PCI cards, and devices, including a second battery if one is installed.

file:///I/SERVICE%20MANUALS/DELL%20MANUALS/LA...ok/Inspiron/9100/9100_SERVICE_MANUAL/begin.htm (2 of 7)6/21/2004 1:15:53 AM

Image 4
Contents Abbreviations and Acronyms Model PP09L February 2004 Rev A00 Before You Begin Preparing to Work Inside the ComputerPage Recommended Tools Screw Identification Each Display Ground Screw 1 each Palm Rest Video Card Back to Contents Memory Module, Mini PCI Card, and Devices Memory ModulePage Page Mini PCI Card Page Page Page Connect the antenna cables to the Mini PCI card Devices Page Page Device latch release Pull the device out of the module bay Back to Contents System Components Back to Contents Subwoofer Page Back to Contents Bluetooth Card Back to Contents Hard Drive Turn over the computer and remove the M3 x 3-mm screwPage Returning a Hard Drive to Dell Fans Page Page Captive screws 2 2 fan cover Hinge Covers Page Page Back to Contents Keyboard Back to Contents Modem Removing the ModemInstalling the Modem Back to Contents Reserve Battery Back to Contents Display Assembly and Display Latch Page Display Page Display Bezel Display Panel Remove the display bezel Display Latch Remove the display bezel Back to Contents Remove the display assembly Keyboard BracketFPC cable pull-tab M2.5 x 6-mm screws 4 3 keyboard bracket Remove the display assembly Remove the keyboard bracket Palm RestPage M2.5 x 6-mm screws 4 2 touch-pad connector Video Card System board connector M2.5 x 6-mm screws 4 3 video card Microprocessor Thermal-Cooling Assembly Removing the Microprocessor Thermal-Cooling AssemblyInstalling the Microprocessor Thermal-Cooling Assembly Microprocessor Module Removing the Microprocessor ModuleInstalling the Microprocessor Module Back to Contents Speakers M2.5 x 6-mm screws Speakers 3 speaker connector Display Release Latch M2.5 x 6-mm screws Display release latch 3 computer base System Board Removing the System BoardPage Page Installing the System Board Flashing the Bios Pin Assignments for I/O Connectors Video ConnectorVideo TV-Out Connector Ieee 1394 Connector Tmds DATA2 Tmds DATA3+ Tmds DATA2+
Related manuals
Manual 162 pages 20.69 Kb Manual 52 pages 11.04 Kb