Dell 6300, 4x00 manual Removing a Scsi Backplane Board

Figure 1-1. Removing a SCSI Backplane Board

1Thumbscrew

2SCSI backplane board

12.Install the new backplane board:

a.While holding the backplane board by its edges, position the board so that the tabs on the computer chassis wall fit through the corresponding slots in the backplane board.

b.Slide the backplane board toward the power-supply paralleling board (PSPB).

c.Secure the backplane board by tightening the captive screw.

13.Connect the 20-pin data cable leading from the system board to the connector labeled "PLANAR" on the backplane board (see Figure 1-2).

support.dell.com Dell PowerEdge 6300 and 4x00 Systems SCSI Backplane Option 1-3