Dell XPS H233, XPS H266 manual System Error Messages

Page 41

System Error Messages

Some system error messages indicate a fatal error, in which case the system cannot usually be rebooted until an appropriate hardware change has been made. The following messages indicate a fatal error:

8042 Gate - A20 Error

DMA Error

DMA #1 Error

DMA #2 Error

FDD Controller Failure

HDD Controller Failure

INTR #1 Error

INTR #2 Error

Table 3-2. System Error Messages

Message

Definition

Probable Causes

 

 

 

8042 Gate —

Gate A20 of keyboard

Defective system

A20 Error

controller is faulty.

board.

Address Line

Address decoding not

Defective system

Short!

properly executed on

board.

 

system board.

 

C: Drive Error

No response from

Incorrect drive settings

 

drive C.

in system setup

 

 

program.

C: Drive Failure

Drive C failed.

Drive C needs

 

 

reformatting.

 

 

Drive interface or

 

 

power cable not prop-

 

 

erly connected.

 

 

Defective drive inter-

 

 

face or power cable.

 

 

Defective drive C.

Cache Memory

Cache memory sub-

Defective

Bad. Do Not

system not functioning

microprocessor.

Enable Cache!

properly.

 

CH-2 Timer Error

Error occurred in sys-

Defective system

 

tem timer 2.

board.

 

 

 

Beep Codes and Error Messages

3-3

Image 41 Contents
659,&0$18$ Page HOOLPHQVLRQ36ä+DQG36+6\VWHPV Page Contents Chapter Removing and Replacing Parts Chapter Beep Codes and Error MessagesFigures IndexTables Page Read This First System Overview System Features Computer Orientation Desktop Computer Features Mini Tower Computer Features Advanced Expansion Subsystem Back-Panel Features TypicalHard-Disk Drive Options Eide SubsystemPower Supply Computer ServiceDC Power Cables DC Power DistributionDC Power Distribution DC Power Connector P1 DC Power Connector Pin AssignmentsDC Power Connectors P2, P3, P4, P5, and P6 Main Memory System Board11. System Board Jumpers System Board JumpersSystem-Board Jumper Descriptions Interrupt Assignments Interrupt AssignmentsDMA Channel Assignments DMA Channel AssignmentsTechnical Specifications Technical SpecificationsSystem Clocks Ports Power Technical Specifications Initial User Contact Basic TroubleshootingExternal Visual Inspection Observing the Boot Routine Internal Visual Inspection Eliminating Resource Conflicts Getting Help Running the DiagnosticsPost Beep Codes Beep Codes and Error MessagesPost Beep Codes System Error Messages System Error MessagesNvram System cannot boot Diskette in drive a From diskette in drive a Contains no operating System Precautionary Measures Removing and Replacing PartsComputer Cover Removal Computer CoverFront-Bezel Removal Mini Tower Chassis Front BezelFront-Panel Insert DrivesDrive Cage Removal Drive Cage25-Inch Drive Removal Inch DriveUpper 3.5-Inch Drive Removal Upper 3.5-Inch DriveLower 3.5-Inch Drive Removal Mini Tower Computer Only Lower 3.5-Inch Drive Mini Tower Computer Only5-Inch Diskette Drive Removal Inch Diskette Drive10. Primary Hard-Disk Drive Removal Primary Hard-Disk DriveSecondary Hard-Disk Drive 11. Secondary Hard-Disk Drive Assembly Removal12. Secondary Hard-Disk Drive Removal 13. Power Supply Removal Power Supply14. Microprocessor-Fan Assembly Removal Microprocessor Fan Assembly15. Card-Guide Assembly Removal Card Guide Assembly16. Control-Panel Board Removal Control Panel Board17. System Board Components System Board Components18. Expansion Card Removal Expansion Cards19. Simm Removal SIMMs21. SEC Cartridge and Heat Sink Removal SEC Cartridge and Heat Sink Assembly22. Battery Removal Battery23. System Board Removal System Board24. System Board Mountings 25. Guide-Bracket Assembly Removal System Setup Screens System Setup ProgramFigure A-1. Main Screen Table A-1. Main Screen Categories Main ScreenTable A-1. Main Screen Categories Figured option, unless you are using a hard-disk IDE Device Configuration SubmenuBoot Options Submenu Table A-3. Boot Options Submenu Categories Advanced Screen Peripheral Configuration Submenu Table A-5. Peripheral Configuration Submenu Categories Chipset Configuration Submenu PnP OS category appears Plug and Play Configuration SubmenuStatus category is set to Locked Security ScreenFigure A-9. Power Screen Table A-9. Power Screen Categories Power ScreenCheck the monitor documentation to make Figure A-10. Exit Screen Table A-10. Exit Screen Categories Exit ScreenPage Index Page Index
Related manuals
Manual 65 pages 6.92 Kb