Card Guide Assembly
tab
card guide assembly
mounting tabs (4)
Figure 4-15. Card-Guide Assembly Removal
To remove the card guide assembly, follow these steps:
1.Disconnect any cables connected to
Note the location of each connector and the orientation of any cables attached to the expansion cards before disconnecting these cables.
2.Remove the
3.Remove the primary
4.If a secondary
5.Disconnect the control panel cable from connector J9D1 on the system board (see Figure
6.Press the four mounting tabs that secure the card guide assembly to the front panel, and press on the tab at the back of the card guide assembly.
7.Lift the card guide assembly, including the control panel cable, out of the chassis.
Removing and Replacing Parts