Dell E5440 owner manual Installing the Display Panel, Removing the Camera

Page 14

a.Lift the mylar tape and disconnect the low-voltage differential signaling (LVDS) cable from the back of the display panel.

b.Remove the display panel from the display assembly.

Installing the Display Panel

1.Place the display panel to the display assembly.

2.Align the display panel in its original position.

3.Connect the low-voltage differential signaling (LVDS) cable to the display panel and attach the tape.

4.Flip the display panel over and tighten the screws to secure the display panel.

5.Install:

a.display bezel

b.battery

6.Follow the procedures in After Working Inside Your Computer.

Removing the Camera

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a.battery

b.display bezel

3.Perform the following steps:

a.Remove the screw that secures the camera and microphone module.

b.Disconnect the camera cable.

c.Lift and remove the camera and microphone module.

14

Image 14

Contents Dell Latitude E5440 Page Contents Specifications Contacting Dell Working on Your Computer Before Working Inside Your ComputerTurning Off Your Computer After Working Inside Your Computer Removing and Installing Components Recommended ToolsSystem Overview Inside View BackRemoving the Battery Inside view Front Removing the SD Card Installing the Battery Installing the SD Card Removing the ExpressCardRemoving the SIM Card Installing the ExpressCardInstalling the SIM Card Removing the Display BezelInstalling the Display Bezel Removing the Display PanelInstalling the Display Panel Removing the CameraRemoving the Keyboard Trim Installing the CameraInstalling the Keyboard Trim Removing the Keyboard Installing the Keyboard Removing the Optical Drive Installing the Base CoverRemoving the Base Cover Installing the Optical Drive Installing the Hard Drive Removing the Hard DriveInstalling the Memory Module Removing the Memory ModuleRemoving the Wlan Card Installing the Wlan CardRemoving the Coin-Cell Battery Installing the Coin-Cell Battery Removing the Display HingeInstalling the Display Hinge Removing the PalmrestPage Installing the Palmrest Removing the Display AssemblyPage Installing the Display Assembly Removing the ExpressCard CageInstalling the ExpressCard Cage Removing the System FanInstalling the System Fan Removing the System Board Page Installing the System Board Installing the Heatsink Removing the HeatsinkRemoving the I/O Board Left Installing the I/O Board Left Removing the I/O Board RightInstalling the I/O Board Right Removing the Power ConnectorInstalling the Power Connector Removing the SpeakersInstalling the Speakers Installing the Status-Light Board Removing the Status-Light BoardFollow the procedures in After Working Inside Your Computer Boot Sequence Navigation KeysSystem Setup Options PS2 SATA-3 Option Description You can also enable or disable Media Card Secure Boot KEK Power Management Post Behavior Virtualization Support Wwan Updating the Bios System and Setup PasswordAssigning a System Password and Setup Password Page Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsBattery Status Lights Device Status LightsSpecifications UMA Display Keyboard AC Adapter Weight 99 kg 4.40 lb 42 kg 5.35 lb Minimu Contacting Dell