Dell 1150 manual Display Assembly, Remove the CD or DVD drive

Back to Contents Page

Display

Dell™ Inspiron™ 1150 Service Manual

Display Assembly

Display Bezel

Display Panel

Display Latch Assembly

Display Assembly

CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

1.Follow the instructions in "Before Working Inside Your Computer."

2.Remove the hard drive.

3.Remove the CD or DVD drive.

4.Remove the keyboard.

5.Remove the EMI shield.

6.Close the display.

7.From the back of the computer, remove the two M2.5 x 5-mm screws.

8.Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.

9.Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board.

10.Remove the two M2.5 x 5-mm screws from each hinge bracket.