Dell M70 manual Display Panel

1	M2.5 x 5-mm screws (6)	4	display panel
2	display bumpers (6)	5	M2 x 3-mm screws (8)
3	display bezel	6	M2 x 3-mm display-cable ground screw

Display Panel

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

1.Follow the instructions in "Preparing to Work Inside the Computer."

2.Remove the center control cover.

3.Remove the display assembly.

4.Remove the display bezel.

5.Remove the eight M2 x 3-mm screws from sides of the display panel.

NOTE: The M2 x 3-mm screw located in the top left of the panel should be removed first and reinstalled first.

6.Remove the M2 x 3-mm screw for the display cable ground, which is located at the bottom of the display panel.

7.Lift the display panel straight up out of the top cover.

8.Press in the tabs on both sides of the top display-cable connector, and pull the display cable connector away from the top flex-cable connector.

NOTE: Do not crimp or crunch cables during reinstallation.