Back to Contents Page
Camera Module
Dell™ Inspiron™ N5020/M5030/N5030 Service Manual
Removing the Camera Module
Replacing the Camera Module
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer.
Removing the Camera Module
1.Follow the instructions in Before You Begin.
2.Remove the battery (see Removing the Battery).
3.Remove the keyboard (see Removing the Keyboard).
4.Remove the palm rest (see Removing the Palm Rest).
5.Remove the display assembly (see Removing the Display Assembly).
6.Remove the display bezel (see Removing the Display Bezel).
7.Release the camera module from the latches that secure it to the display cover.
8.Lift the camera module off the display cover.
1 | camera module | 2 | latches (2) |
|
|
|
|
|
|
|
|
|
|
|
Replacing the Camera Module
1.Follow the instructions in Before You Begin.
2.Slide the camera module under the latches until it is fully seated.
3.Replace the display bezel (see Replacing the Display Bezel).
4.Replace the display assembly (see Replacing the Display Assembly).