Dell PP30L manual Flash Cache Module, Removing an FCM Replacing an FCM

Back to Contents Page

Flash Cache Module

Dell Precision™ Service Manual

Removing an FCM

Replacing an FCM

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.

The Flash Cache Module (FCM) is an internal memory module that helps improve the performance of your computer. You can install the module in either the WWAN or WPAN Mini-Card slot.

NOTE: This card is only compatible with the Windows Vista® operating system.

If you ordered an FCM with your computer, the card is already installed.

Removing an FCM

1.Follow the procedures in Before Working on Your Computer.

2.Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).

3.If removing a module from the WPAN Mini-Card slot, remove the left hinge cover (see Removing the Hinge Covers).

4.Remove the M2 x 3-mm screw from the FCM. The module pops up to a 30-degree angle to the system board.

5.Slide the FCM out of its connector.