Dell D505 service manual Inch Display Panel

1.Follow the instructions in "Preparing to Work Inside the Computer."

2.Remove the keyboard.

3.Remove the display assembly.

4.Use a plastic scribe to pry the six display bumpers out of the screw holes located on the front of the bezel.

5.Remove the six M2 x 5-mm screws located on the front of the bezel.

NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.

6.Starting at the bottom of the display panel (by the DELL™ logo), use your fingers to separate the bezel from the top cover by lifting the inside edge of the bezel away from the top cover.

Display Panel

14.1-Inch Display Panel

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

1.Follow the instructions in "Preparing to Work Inside the Computer."

2.Remove the keyboard.

3.Remove the display bezel.

4.Remove the eight M2 x 5-mm screws from each side of the display-panel adapter rails.

5.Lift the display panel, and rotate the display panel out of the display cover.

6.Remove the four M2 x 3-mm screws from each side of the display panel to remove the adapter rails.

When reinstalling the adapter rails to the replacement display panel, orient the rails so that the "This side up" markings are facing you, and then reattach the rails with the four M2 x 3-mm screws. (The "This side down" markings on the rails should be visible from the rear side of the display panel.)