Dell 1000 owner manual Hibernate Mode

•Depending on how you set the power management options on the Advanced tab (see "Configuring Power Management Settings" on page 50) in the Power Options Properties window, use one of the following methods:

–Press the power button.

–Close the display.

–Press <Fn><Esc>.

To exit standby mode, press the power button or open the display depending on how you set the options on the Advanced tab. You cannot make the computer exit standby mode by pressing a key or touching the touch pad.

Hibernate Mode

Hibernate mode conserves power by copying system data to a reserved area on the hard drive and then completely turning off the computer. When the computer exits hibernate mode, it returns to the same operating state it was in before entering hibernate mode.

NOTICE: You cannot remove devices or undock your computer while your computer is in hibernate mode.

Your computer enters hibernate mode if the battery charge level becomes critically low.

To manually enter hibernate mode:

•Click the Start button, click Turn off computer, press and hold <Shift>, and then click Hibernate.

or

•Depending on how you set the power management options on the Advanced tab in the Power Options Properties window, use one of the following methods to enter hibernate mode:

–Press the power button.

–Close the display.

–Press <Fn><Esc>.

NOTE: Some ExpressCards may not operate correctly after the computer exits hibernate mode. Remove and reinsert the card (see "Removing an ExpressCard or Blank" on page 61), or simply restart (reboot) your computer.

Using a Battery

49