Back to Contents Page
Setting Up Your Monitor
Dell™ E178FP Flat Panel Monitor User's Guide
Connecting Your Monitor
Using the Front Panel Buttons
Using the OSD
Using the Dell™ Soundbar (Optional)
Connecting Your Monitor
CAUTION: Before you begin any of the procedures in this section, follow the Safety Instruction.
1.Turn off your computer and unplug its power cable.
2.Connect the blue (analog
3.Connect the power cable for your display to the power port on the back of the display.
4.Plug the power cables of your computer and your display into a nearby outlet. Your monitor is equipped with an automatic power supply for a voltage range from 100 to 240 Volt at a frequency of 50/60 Hz. Be sure that your local power is within the supported range. If you are unsure, ask your electricity supplier.
5.Turn on your display and computer.
If your monitor displays an image, installation is complete. If it does not display an image, see Troubleshooting.
Using the Front Panel Buttons
Use the control buttons on the front of the monitor to adjust the characteristics of the image being displayed. As you use these buttons to adjust the controls, an OSD shows their numeric values as they change.
The following table describes the front panel buttons:
A
B
MENU
The 'MENU' button is used to open the
Use this button for direct access to the 'Brightness' and 'Contrast' control menu.