Dell E2011HC appendix Setting Up the Monitor, Attaching the Stand, Connecting Your Monitor

Back to Contents Page

Setting Up the Monitor

Dell™ E2011H Monitor User's Guide

Attaching the Stand

Connecting the Monitor

Organizing the Cables

Attaching the Soundbar (Optional)

Removing the Stand

Wall Mounting (Optional)

Attaching the Stand

NOTE: The stand is detached from monitor when it is shipped from the factory.

NOTE: This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for set up instructions.

To attach the monitor stand:

1.Remove the cover and place the monitor on it.

2.Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.

3.Press the stand till it snaps into its place.

Connecting Your Monitor

WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions.

To connect your monitor to the computer:

1.Turn off your computer and disconnect the power cable.

2.Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not connect both cables on the same computer. Use both the cables only when they are connected to two different computers with appropriate video systems.

Connecting the White DVI Cable

Connecting the Blue VGA Cable