Data Technology 2500 user manual Do you want to select a new terminal type? Y/N

Page 10

Quick Update Steps

CAUTION: Turning off system power or removing the Boot Files Disk while 2500 is updating system ROM damages 2500.

Press Y to confirm the update of the system software. 2500 updates the system ROM to reflect the new version of system software.

8 After the “>” is displayed, press Z (capital Z) and then ENTER. The powerup screen is displayed with the following prompt:

Do you want to select a new terminal type? (Y/N)

a)If the current terminal type is DEC VT100, press N and then ENTER. The Main Menu is displayed. Update the hard drive as described in the next section.

b)If the current terminal type is not DEC VT100, press Y and then ENTER, and select the terminal type you want to use. Press ENTER to accept the selection.

2500 responds with the following prompt:

Save terminal type as power on default? (Y/N)

Press Y and then ENTER to save your current terminal type as the powerup default. The Main Menu is displayed.

Update the hard drive as described in the next section.

ProMaster 2500 V8.7 User Notes

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Contents ProMasterŠ Device Lists on UniFam 8.7/TaskLink 7.30 CD Š Update from CDWhat’s New in Version Š TaskLink DOS Version RequirementDevice Name Package Pins Š Devices Now Listed under SST OnlyProMaster 2500 V8.7 User Notes Š Changes to Terminal Mode RemindersŠ PPI Adapter information is Displayed in the Message Bar Š Names Indicate Location of Configuration BlocksŠ Use Device Guide Only With 150- and 220-mil SOICs High Density Diskette Creating Floppy Diskette Set from CDFormat Disk screen Status window describing disk contents Quick Update Steps TaskLink DOSDo you want to select a new terminal type? Y/N Update the Hard Drive
Top Page Image Contents