Data Technology 2500 user manual Status window describing disk contents

After the disk is created, attach the floppy diskette label.

Click on the first file in the directory to launch the WinImage Self Extractor.

On the FORMAT DISK screen, move the cursor to “Are you sure (Y/N)?” and press Y.

3

4 Insert a blank 1.44 MB floppy disk into the floppy disk drive on your programmer. Press ENTER on your keyboard to format the floppy disk.

5

6

7

Repeat the formatting process for the remainder of the disks.

Insert the “UniFam 8.7/TaskLink 7.30” CD into your PC's CD-ROM drive.

Browse to the 'X:\floppies\auto_v87' directory (where X is the CD-ROM drive).

Note: When you insert the “UniFam 8.7/TaskLink 7.30” CD into your PC, the TaskLink v6.1 install program will auto-launch. You may either install TaskLink at this time, or cancel and install it at a later time.

8

9 A status window will pop up describing the disk contents for this image. To create a label for the disk, copy the content information from the monitor onto a floppy diskette label for use in Step 11 below.

Status window describing disk contents

10 When prompted, insert a disk (formatted as described above) into your PC's floppy diskette drive. Click OK to start the disk creation process.

11

12 Repeat Step 8 through Step 11 and select the next file in the directory until you have completed the entire disk set.

ProMaster 2500 V8.7 User Notes 8