Settings
Name
Serial Settings
USB Settings
Discoverability mode
Connectivity mode
Security mode
Fixed PIN
Set Master/Slave Policy
Client Profile
Server Profile
Wireless
Set Serial Interface
Configuration over Bluetooth
Power Save mode
ESC sequence timing
Value
APEX#, where # matches the printer model 115200,8,n,2,n
57600, 8, n, 2, n Generally Discoverable GAP Connectable Security Disabled
0 (Zero)
Always let the connecting device select the master/slave role on incoming connections Disable Client Services
Serial Port Profile Server enabled disabled, forward to host only RS232
Enabled
Allow Sleep mode only
500ms before ESC command & 500ms thereafter
The Bluetooth™ Interface Power Modification
The Bluetooth™ interface increases the battery power consumption by 50mA. To compensate for the increased power demand, the trickle charge rate is modified to help extend the life of the internal battery cartridge. The printer modification is such that the printer can be set to operate in either the MANUAL POWER OFF or CONTINUOUS ON mode. For Dip Switch settings on Power Save mode please refer to the Dip Switch Table above.
Manual Power OFF Mode
For the printer to be in Manual Power OFF mode Dip Switch # 8 must be OFF. When demonstrating RF wireless communication, turn the printer on by pressing the ON switch located at the front of the printer. The printer will remain active waiting for the wireless print command. Pressing the ON switch again will turn the printer OFF. For each wireless demonstration, turn the printer on by pressing the ON switch. Operation in this fashion will greatly extend the life of the battery cartridge. Unless the ON/OFF switch is pressed the printer will stay ON until the battery drains completely.
Automatic Power OFF Mode
To have the printer automatically SHUT DOWN after a period of time, turn Dip Switch # 8 ON. The printer will turn OFF after 99 seconds. The value of the default timer can be changed by using the command ESC M n1n2 0 CR command described earlier in the manual. Once power is cycled the printer reverts to the default 99 second value.
Infrared Communications (Option)
Set Dip Switch 1 to ON position. The printer can be powered up by pressing the power <ON/OFF> switch. If no IrDA connection is made, the printer will automatically power down to a lower power level to conserve battery life. It will remain in a “sleep” mode until an IrDA connection is made, at which time the printer will “wake” and print the requested data. Pressing the power switch again will turn the printer <OFF>.
56