http://www.cartft.com, Cool Embedded PCs
1.0 Introduction
Thank you for purchasing the VoomPC-2 mini-ITX vehicle enclosure!
The VoomPC-2 was designed to work with a wide variety of main boards such as the VIA mini-ITX boards as well as low power Pentium-M OR Core 2 Duo. Please note that powering full power P4 or AMD systems is not recommended due to excessive heat dissipation.
2.0 Required tools
Battery
Ignition
Amplifier Enable
+ | + | Reverse and | Switch Logic | 6-30V ATX PSU | PC ATX |
| forward protection |
| - | | | | power |
GND | | | | MotherBoard |
| | | |
| | | 8bit MCU | J6 | ON/OFF switch |
| | | J8 | Optional On/OFF switch |
| | | |
| J2 | | M1-ATX | J4 | LED |
| | | |
In order to install the VoomPC-2 in your vehicle you will need the following:
-Phillips screwdriver and Wire cutter / stripper
-Few feet of wire (AWG 12-16), preferably color coded, used for power input.
VoomPC-2 Installation Guide | Page 3 |
