Curtis Computer VoomPC-2 manual Bottom mounting plate

Page 5

http://www.cartft.com, Cool Embedded PCs

7)Install the HDD and CDROM (optional) into the metal bracket and connect to the motherboard using the IDE cable.

8)Install the motherboard I/O shield at the back of the VoomPC-2 enclosures

Figure 1.1, bottom mounting plate

9)Your final assembly should look similar to Figure 1.1. Slide the bottom plate into the extrusion and stop half way into the slide. Connect the power input faston wires to the Power Supply unit. (In case you are using a Power Amplifier, connect the AMP RMT wires to the Power Supply Anti-Thump header.

10)Hook up Monitor, Keyboard, etc and test your system by turning ignition ON.

11)Secure the VoomPC-2 using the 4 front/back mounting screws. If you don’t want to drill holes into your car chassis, stick large Velcro pads to the bottom plate of the VoomPC-2 (the hook side) and attach to your car’s carpet and a strong adhesion will be formed.

VoomPC-2 Installation Guide

Page 5

Image 5
Contents Before you start… Installation GuideVoomPC-2 Installation Guide Required tools IntroductionBottom mounting plate VoomPC-2 installation stepsBottom mounting plate Mechanical Power Connector Wiring DiagramSupport and warranty