Atlantic Technology IWTS-155 instruction manual Cutting the Opening, Caulk or similar substance

	Installation	5
Instruction Manual
Mounting the IWTS-155 Speakers	IMPORTANT: If the IN-BOX-155 is not used in New Construction situ-
	ations, it's recommended that the wall cavity be treated with acoustic
NOTE: We always recommend a professional be involved in the	filler and that all extraneous wires, etc. in the wall cavity are securely
	"buttoned down" so there is no unwanted vibration or rattling after
installation of the IWTS-155 LCR, if at all possible.
	the speaker is installed. Try to make the wall cavity as airtight as pos-
The IWTS-155 LCR can be easily mounted in most any standard wall mate-	sible by sealing all the stud-to drywall seams with a flexible silicon
rial,from ½ to 1½ inches thick. Use the grille/frame assembly GFR-155,	caulk or similar substance.
sold separately. The GFR's rotating wall clamps firmly fix it to the wall	It is also recommended that you create an ‘enclosure’ by install-
surface after the proper cutout has been made.An important precautions
	ing cross studs between the existing vertical studs. Space these
to take before mounting:
	cross studs approximately 30-36” apart. That will enclose the proper
Keep the sides of the actual mounting hole at least ½ inch away from	amount of air volume needed for the 155 to achieve its optimal per-
beams or studs to ensure that the clamps have adequate room to rotate.	formance. Again, take care to seal these cross studs to the sheetrock.
A stud or other obstruction that’s too close will stop them from properly	Installation of the IWTS-155 in Existing
doing their job.
Installation of the IWTS-155 in New	Construction
	Removing and Installing the Grille
Construction with Optional Back Box

For new construction,we highly rec- ommend that you use the optional Back Box IN-BOX-155. The Back Box provides the correct acoustic environment for the 155 LCR and ensures its THX-level performance. The rotator clamps (sometimes called "dog legs") will easily grab the combined thickness of 5/8" sheetrock and the 3/8" back box's front panel. The sheetrock must be adhered to the front panel of the back box very solidly and positively.

Use very liberal amounts of a high-quality construction adhesive, such as Liquid Nails, to ensure a secure, vibration-free bond.

Please see the installation instructions that come with the IN-BOX-155 for more details.

Installation of the IWTS-155 in New Construction without Optional Back Box

There may be new construction situations where the Back Box IN-BOX-155 is either not desired or not feasible. For those situa- tions, Atlantic Technology offers an optional Rough-in Frame Kit IN-NC-155 to ease installation in new construction. Instructions for its use are included with this kit. Ask your Atlantic dealer for more details.

Remove the grille from the speaker using an awl or the point of a drywall screw in a grille opening near one of the grille corners.Slowly pry the grille out, being careful not to damage the speaker’s frame or its finish.

To re-install the grille later,press it carefully into the appropriate opening in the frame assembly. Since it’s designed to fit snugly, please take your time and use care when installing the grille.

Cutting the Opening

After determining the best location for the speaker as outlined above, use the enclosed template to cut the proper size hole.

IWTS-155 LCR 14 1⁄4” x 7 1⁄8”

WARNING: Exercise extreme care before making any wall cuts to ensure that you will not cut through any wires, pipes, or other items that may be in the wall. You may sometimes, but not always, be able to determine the approximate location of wires and pipes by looking at the locations of nearby outlets and plumbing. But their location or absence is never an assurance that there is not something within the wall cavity.