Emerson CF770WW01, CF770TG01, CF770BS01, CF770OB01 How to Put Your Ceiling Fan Together, result

How to Put Your Ceiling Fan Together

1.Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 5.

PIN

HANGER

BALL

DOWNROD

SETSCREW

Figure 1

2.Separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the cle- vis pin and secure with the hairpin clip (Figure 2). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the downrod to make sure the clevis pin is properly installed.

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tight- ened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 2) could result in the fan falling.

MOTOR COUPLING

3/16-24 x 1/2"

SETSCREW

CLEVIS PIN	HAIRPIN
	CLIP

JAM NUT DOWNROD

4.Make sure the grommet is properly installed in the coupling cover, then slide the coupling cover on the downrod until it rests on the motor housing. Place the ceiling cover over the downrod. Be sure that the ceiling cover and the coupling cover are both oriented correctly (Figure 3).

CEILING

COVER

DOWNROD

GROMMET

COUPLING COVER

Figure 3

5.Reinstall the hanger ball (Figure 4) on the downrod as follows. Route the three 80” motor leads through the hanger ball. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.

!WARNING

It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are proper- ly installed could result in the fan falling.

PIN

HANGER

BALL

MOTOR	HAIRPIN CLIP
COUPLING	3/16-24 x 1/2"
CLEVIS
	SETSCREW
PIN
			DOWNROD
			SETSCREW
JAM NUT
Figure 2			Figure 4
3. Back off the jam nut until it rests loosely against the
			6. The fan comes with blue, black and white leads
setscrew head. Install the setscrew in the motor
coupling (Figure 2) and tighten securely while			that are 80-inches long. Before installing the fan,
pulling up on the downrod. Using a 5/16-inch open			measure up approximately 6 to 9-inches above top
end wrench or pliers, tighten the jam nut securely			of hanger ball/downrod assembly. Cut off excess
against the motor coupling.			leads and strip back insulation 1/2-inch from end of
NOTE: The setscrew and jam nut must be properly			leads.
installed as described above, or fan wobble could			7. Mount blade flanges to fan blades using three
result.			3/16-24 x 1/4” slotted Phillips screws and three
		4	blade washers (Figure 5).