Britax Child Seat manual Lap-Belt Installation

Installation : Forward-Facing

Lap-Belt Installation

• Figure A illustrates a typical forward-facing, lap- belt installation.

• When not in use, always store the LCS connectors in storage slots. See page 28.

WARNING! AForward-facing

•This child seat must NOT be used forward- facing for children less than one year of age OR who weigh less than 9.1 kg (20 lbs).

•This child seat must be in full upright position when installed forward-facing.

•Always use the Versa-Tether when the child

seat is	installed forward-facing. Check your	b
vehicle	owner’s manual for approved tether
anchor locations.

1Place the child seat forward-facing on the vehicle seat. Ensure the bottom of the child seat base is in full contact with the vehicle seat.

2 Remove the Versa-Tether from the pouch	c
and place it up and over the child seat back.

3Pull the vehicle belt out, then pass it through the forward-facing belt path to the opposite side of the child seat (Fig. B).

4Verify that the vehicle belt is not twisted, then buckle (Fig. C).

5Push the child seat firmly into vehicle seat while tightening the vehicle belt.

Installation : Forward-Facing

6Attach the Versa-Tether®hook to the designated tether anchor for the chosen seating position. Remove all slack from the tether to secure. Store excess webbing in the tether pouch. See pages 25 – 27.

7Verify that the vehicle belt is tight, locked, and child seat is secure.

•The child seat is secure when it cannot be moved front-to-back or side- to-side more than 2.5 cm (1 inch) at the belt path. If the child seat is not secure, repeat the procedure or use an alternate seating location.

22 23