![](/images/new-backgrounds/1217110/21711029x1.webp)
Installation :
Installation :
Using the Versa-Tether®
1Consult your vehicle owner’s manual for designated tether anchorage locations.
2Locate the tether on the rear of the child seat and remove the tether from the pouch.
3Place the tether up and over the child seat back.
4Install the child seat using the LUAS or the vehicle belts according to the instructions in this manual.
5Tilt the tether release tab ; then pull to fully extend the tether strap into a “V” shape.
6Locate the hook on the strap and loosely attach the tether to the vehicle’s designated tether anchor.
•See figure A for
•See figures B and C for
7Secure the child seat by a vehicle seat belt OR with the LCS connectors.
8Pull the tether adjuster strap to remove all slack. Roll up excess webbing and store in tether pouch.
9Verify there is tension in the tether strap and that the child seat is properly secured.
OR |
A |
OR |
b |
c
Tether Connector Strap
WARNING! Only use tether connector strap for rear-
facing tether installation.
Because every vehicle model is different, sometimes you cannot find a location to properly anchor the tether. Use the tether connector strap to assist in creating an anchor point (Fig. D).
1Find a fixed vehicle anchor point that is bolted to the floor.
•If you cannot find an acceptable location to d create an anchor point, contact the vehicle manufacturer to identify a suitable tether connection point.
2Route the strap around the fixed vehicle anchor point.
3Take the metal
4Pull the metal
5Use the
tether strap.
NOTE : Store the tether connector strap in the tether pouch when not in use.
•The child seat is secure when it cannot be moved
26 | 27 |