![](/images/new-backgrounds/1217110/21711021x1.webp)
Installation :
Lower Universal Anchorage System (LUAS) Installation
• | Figure A illustrates a typical |
|
|
| installation. |
|
|
• | Verify that your vehicle is equipped with LUAS |
|
|
| anchors. If LUAS anchors are not available, you must |
|
|
| use vehicle belt installation methods. |
|
|
| WARNING! | A | |
| • This child seat must NOT be used forward- | Release |
|
| facing for children less than one year of age OR | Top | |
| who weigh less than 9.1 kg (20 lbs). | Button |
|
| • This child seat must be in full upright position |
|
|
| when installed |
|
|
| • Always use the |
|
|
| is installed | B |
|
| owner’s manual for approved tether anchor |
| |
| locations. |
|
|
IMPORTANT: Check that the LCS connector strap is |
|
| |
tight and not twisted, and that the LCS connectors |
|
| |
are in an upright position (Fig. B) to ensure proper |
|
| |
installation. |
|
| |
1 | Remove the LCS connectors from storage slots | C |
|
| under the cover. See page 28. Pull both LCS |
| |
| connectors completely through the child seat’s |
|
|
|
|
| |
| are on the outside of the shell. |
|
|
NOTE : Child seat is assembled in |
|
| |
mode. |
|
| |
2 | Press and hold one LCS adjuster release button, |
|
|
| then pull to extend the LCS strap to full length. | D |
|
| Repeat on the other end of the strap. |
| |
3 | Thread the appropriate LCS connector through |
|
the
Installation :
4Place the child seat sideways in the upright position on the vehicle seat with the back of the child seat facing you.
5Remove the
6Verify that the LCS strap is not twisted and attach
the closest LCS connector to the vehicle seat back | e |
to the farthest LUAS anchor (Fig. B). |
|
|
•A positive click confirms attachment.
NOTE : It may be necessary to switch LCS connectors as shown on page 28 if ANY of the following
conditions exist : |
|
• LCS connector is not in an upright position (Fig. D). |
|
• LCS strap is twisted. |
|
• A positive click is NOT heard when the LCS connector | F |
connects to the LUAS anchor. | |
NOTE : If a positive click is not heard, but the LCS |
connector is in an upright position, you should not switch the LCS connector. The strap may be too tight or twisted, or there may be debris in the LCS connector.
7Rotate the child seat into the
8Verify that the LCS strap is not twisted and attach the remaining LCS connector to the adjacent LUAS anchor (Fig. D).
•A positive click confirms attachment.
9Push the child seat into the vehicle seat while pulling the LCS adjuster strap tight (Fig. F). Ensure the bottom of the child seat base is in full contact with the vehicle seat.
10Attach the
11Verify all connections are secure and that the child seat is stable.
•The child seat is secure when it cannot be moved
18 | 19 |