Citizen Systems CMP-10 manual Communication Via Serial Port Cable

Page 27

4.4 Communication Via Serial Port (Cable)

For communication with RS-232C, prepare dedicated serial cable. Open the serial port cover and while holding the connector with the wording marked “Push” faciing upward, insert the connector into the serial port.

Here, hold the connector with the surface marked “Push” down. Connect the other end of the cable of the cable to the device to be connected.

To disconnect the connector, securely do it while pressing the portion marked “Push”.

This part is fixed to the body; therefore, it cannot be detached as shown in the figure.

Rubber projection

Serial port cover

Lift and open the serial port cover.

Insert serial cable:

To replace the serial port cover, press in the rubber packing till the cover seats firmly.

CAUTION!

If the cable is connected with Power ON, turn the Power OFF once and then turn the Power ON again to activate the connection with serial cable.

Set the flow control setting of the device to be connected to Xon/Xoff. In case of hardware control (DTR/DSR control), the Power switch may become disabled.

— 23 —

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Mobile Thermal Printer FCC Declaration of Conformity Compliance Statements CE Declaration of Conformity General Precautions Definition of Pictogram About PictogramPrecautions in Handling Printer Precautions on Using Printer Precautions on Using Battery Precautions on Setting Print Paper Precautions on Using Thermal Paper Print Paper Precautions on Using AC Adapter Precautions on Using Special Serial CableTable of Contents Introduction FeaturesType Classification Included and Optional AccessoriesFeature Parameters General SpecificationsFeature Parameters Feature Parameters Explanation of Printer Parts LED IndicatorsCommunication Port and Switch Buzzer Inside of Paper CoverBottom Surface and Battery Cover Dimensions and Views Replacing the Paper Roll OperationMethod of Charging Communication by IrDA Communication Via Serial Port Cable Page Removing the Battery Pack Installing the Battery Pack Interface Selection Auto Power OFFLow Battery Detection FunctionSelf Testing and Internal Settings Monitoring the Print Head OverheatingPrint Area List of Commands GS H Northern America Other Areas Maintenance and ServiceHow to Mount Belt Clip Appendix Handling Belt Clip KITMounting Rubber Feet Memo Memo Memo
Top Page Image Contents