Citizen Systems CLP-9301, CLP-9001 Etat DE Conformite EMI a Lusage DES Utilisateurs Canadiens

Page 4

EMI COMPLIANCE STATEMENT

FOR CANADIAN USERS

This Class A digital apparatus complies with Canadian ICES-003.

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This equipment is designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Use shielded cables to connect this device to computers. Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.

ETAT DE CONFORMITE EMI A L'USAGE

DES UTILISATEURS CANADIENS

− ii −

Image 4

Contents CLP-9001/9301 Page − i − Etat DE Conformite EMI a Lusage DES Utilisateurs Canadiens Important Safety Instructions − iv − Introduction Table of Contents Configuring Your Printer Using the Menus − viii − Chapter UnpackingChecking items inside the accessory box Safety Precautions Safety signs− 4 − − 5 − − 6 − − 7 − − 8 − Names and Functions of Printer Parts Printer main bodyOpening/closing and detachment of the front cover Opening/closing of the right side cover− 10 − − 11 − Control panel LCD DisplayMode key Stop keyFeed key Pause keyMenu key UP keyDown key Select keyMedia Paper and Ribbon Types of mediaBlack mark tag Center-punched hole tagCorner-with-a-radius cut tag Label Paper size Loading the paper − 20 − Suggestion − 22 − − 23 − Loading the ribbon − 25 − − 26 − Printhead pressure adjustments Paper sensor adjustments Power on and Using the Control Panel Connecting to a power outletTurning the printer on Ready Mode and Menu Mode Navigating the Menu System Changing Menu Values Permanently Saving Printer Settings Producing a Test or Configuration Print Turning the printer OFF Configuring Your Printer Using the Menus Group MenuSetup Menu System Setup Menu − 40 − After Print Menu Interface Setup Menu Permanently Saving Settings Menu Test Mode Menu Menu Mode Description − 45 − − 46 − − 47 − − 48 − Troubleshooting Items to check in case of trouble− 50 − Error messages and corrective actions − 52 − Maintenance Printer careCleaning method Specifications General specificationsInterfaces SpecificationsXON/XOFF protocol DTR protocol Pin assignmentParallel interface Specifications Printable area Adjustable sensor Auto-Cutter optional Peeler optional Peeler specificationsEnvironmental requirements