Citizen Systems CLP-9301, CLP-9001 user manual 26

Page 36

Chapter 4 Media (Paper) and Ribbon

9.Close the right side cover and then close the front cover, allowing the magnetic catch to firmly hold the front cover.

The ribbon is now loaded.

NOTE

The following procedure may help you load the ribbon more easily. First insert the bobbins into the source and destination ribbon cores, affix the adhesive tape at the end of the ribbon and then wind the ribbon around the bobbin until the tape is hidden. Finally, set the ribbon by passing it through the lower side of the printhead block.

CAUTION

Be sure to wind the ribbon sufficiently over the adhesive leader (or clear adhesive tape) being fastened to the end of the ribbon before closing the right side cover.

− 26 −

Image 36

Contents CLP-9001/9301 Page − i − Etat DE Conformite EMI a Lusage DES Utilisateurs Canadiens Important Safety Instructions − iv − Introduction Table of Contents Configuring Your Printer Using the Menus − viii − Chapter UnpackingChecking items inside the accessory box Safety Precautions Safety signs− 4 − − 5 − − 6 − − 7 − − 8 − Names and Functions of Printer Parts Printer main bodyOpening/closing and detachment of the front cover Opening/closing of the right side cover− 10 − − 11 − Control panel LCD DisplayMode key Stop keyFeed key Pause keyMenu key UP keyDown key Select keyMedia Paper and Ribbon Types of mediaCenter-punched hole tag Black mark tagCorner-with-a-radius cut tag Label Paper size Loading the paper − 20 − Suggestion − 22 − − 23 − Loading the ribbon − 25 − − 26 − Printhead pressure adjustments Paper sensor adjustments Power on and Using the Control Panel Connecting to a power outletTurning the printer on Ready Mode and Menu Mode Navigating the Menu System Changing Menu Values Permanently Saving Printer Settings Producing a Test or Configuration Print Turning the printer OFF Configuring Your Printer Using the Menus Group MenuSetup Menu System Setup Menu − 40 − After Print Menu Interface Setup Menu Permanently Saving Settings Menu Test Mode Menu Menu Mode Description − 45 − − 46 − − 47 − − 48 − Troubleshooting Items to check in case of trouble− 50 − Error messages and corrective actions − 52 − Maintenance Printer careCleaning method Specifications General specificationsSpecifications InterfacesXON/XOFF protocol DTR protocol Pin assignmentParallel interface Specifications Printable area Adjustable sensor Auto-Cutter optional Peeler specifications Peeler optionalEnvironmental requirements