3. DISASSEMBLY AND REASSEMBLY
3-1 Disassembly Procedure
1.Remove a shield cover.
(1)Insert a regular screwdriver into a slot in the top(or bottom) of the shield cover.
(2)Raising the end of the regular screwdriver, remove the shield cover.
2.Remove a control board.
(1)Using a Phillips screwdriver, loosen an earthing plate setscrew(PHT, M2.6 X 8) and FG cable setscrew(PHT, M2.6 X 8).
(2)Using the Phillips screwdriver, loosen two screws(M2.6 x 8) fixing an inner board.
(3)Disconnect a connected from the board.
(4)Remove an insulating sheet.
3.Remove the front covers(upper and lower).
(1)Push out a roller pin from the lower front cover(where the printing paper comes out).
(2)Paying attention to a harness projecting from the front cover, remove the front cover.
- 5 - | CITIZEN |