BioStar P4M800 manual Installing System Memory

Page 10

P4M800 Pro-M7

2.3INSTALLING SYSTEM MEMORY

DDR2_A1

1.Unlock a DIMM slot by pressing the retaining clips outward. Align a DIMM on the slot such that the notch on the DIMM matches the break on the Slot.

2.Insert the DIMM vertically and firmly into the slot until the retaining chip snap back in place and the DIMM is properly seated.

8

Image 10
Contents FCC Information and Copyright Table of Contents Chipset DimensionFeatures Operating Systems10/100 LAN PHY Super I/OOn Board IDE Serial ATAFront Side Onboard Peripherals Rear Side ConnectorsPackage List LGA775 Hardware Installation Installing Central Processing Unit CPUStep JCFAN1 CPU Fan Header FAN HeadersInstalling System Memory FDD1 Floppy Disk Connector Connectors and SlotsPCI1~PCI3 Peripheral Component Interconnect Slots CNR1 Communication Network Riser Slot HOW to Setup Jumpers JUSBV1/JUSBV2 Power Source Headers for USB portsDetail Settings JATXPWR1 ATX Power Source Connector JATXPWR2 ATX Power Source ConnectorJUSB2/JUSB3 Headers for USB 2.0 Ports at Front Panel JPANEL1 Front Panel HeaderJCDIN1 CD-ROM Audio-in Connector JFAUDIO1 Front Panel Audio HeaderJCMOS1 Clear Cmos Header JCI1 Chassis Open HeaderJSATA1~JSATA2 Serial ATA Connectors JSPDIFO1 Digital Audio-out ConnectorAward Bios Beep Code Bios UpdateExtra Information CPU Overheated Troubleshooting Problem SolutionIntroduction System RequirementInstallation Tray Icon Warpspeeder Includes 1 Tray Icon and 5 PanelsMain Panel contains features as follows Main PanelVoltage Panel Overclock Panel contains the these features Overclock PanelHardware Monitor Panel About Panel P4M800 Pro-M7