AOC 540 user manual Adjusting the OSD Settings

Page 11

Operating Instructions

LM540

Adjusting the OSD Settings

1.Press the MENU button to open the OSD window.

2.Press the < or > buttons until the desired function is highlighted.

3.Press MENU to open the function’s window.

4.Press the < or > buttons to change the settings of the function.

5.To save and exit, highlight the EXIT icon and press MENU or leave the monitor alone for 10 seconds. If you want to adjust any other function, repeat steps 2-4.

Note: When the OSD window is open, the input signal timing settings appear at the top.

H:stands for horizontal frequency and

V:stands for vertical frequency.

LM540

11

17NOV04

Image 11

Contents Inch TFT LCD Monitor User’s ManualFCC Statement For Your SafetyPrecautions General Notes Using the Right Power CordSpecial Notes on LCD Monitors Before You Operate the Monitor Installing & Removing the Base General FeaturesPackage Contents Connecting the Wires Using the Power Cord Supplied Adjusting the Viewing Angle Before You Operate the Monitor Nstall An Optional Wall Mounting Arm Not Supplied Front Panel Buttons Operating InstructionsAdjusting the OSD Settings How to Install INF & ICM File Plug & Play DDC1/2B FeatureProblem Possible Solution Technical Support FAQError Message Possible Solution Resolution Vertical Pixels Frequency Resolution ChartAppendixLM540 SpecificationsAppendix Optimal Viewing Mode 1024 x 768 x 60 HzStandard Resolution Horizontal Vertical Pixels Frequency Factory Preset Timing TablePin Number Description Connector Pin Assignment